2000 Toyota Tundra Rear Axle Removal
Last year I thought its was shoes and wheel cylinder replaced those but issues continued.
2000 toyota tundra rear axle removal. Most people dont own a press so heres how a little ext. There are 4 bolts for each rear axle. I have a 2002 tundra 47 l engine 2 wheel drive.
Next remove the 4 17mm nuts that hold the axle and bearing assembly to the axle tube. Ive been looking for a replacement rear axle assembly or at least a rear axle housing for my 4x4 with ABS and an E-locker. The issues is it feels like every time I stop at a redlight stop sign or in general my driver side rear drum hangs up.
The lines are directly above the axle. Genuine Toyota Parts the Right Choice. It seems too difficult to find a clean assemblyhousing with that exact configuration but I see.
Forums Tundra Discussion 1st Gen Tundras 2000-2006. They are located behind the rear brake drums. 10 mm wrench Third remove the drain and fill plugs from the axle and let the fluid drain out into a container for proper disposal.
I recomend draining and changing your rear differential fluid too because if the fluid by run out of axle housing. Im installing a rear axle bearing oil seals on my 1985 Toyota Pickup 4x4 without using a press. I have been told that timkin bearings are not as good as they used to be years ago.
Toyota Tundra SR5 with Toyota 80 Series Axle 2000 Rear Axle Seal by Nitro Gear Axle. When a rear axle seal goes bad its typically noticeable by gear oil leaking all over a rear wheel and it may get into the brake drum and reduce rear brake feel. They cant seem to get the bearing and housing to bust loose from the axle.