2000 Toyota Tundra Rear Bumper Removal

Remove tail lamp four 8mm nut perside unplug wires.

2000 toyota tundra rear bumper removal. If you wish to remove the entire set up from the frame remove the bolts attaching the brackets to the frame rails. -wrenched the wheel to the left or right side depending on which side we will analyze first. -assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any-if you have headlight washers disconnected the hoses so the liquid will not escape on earth should prepare a special container.

The forward two are in an open slot so just loosen them the bumper will tilt down and you can slide it slightly forward to remove. Unplug and remove the Trailer Plug. Toyota RAV4 CA20W 2000-2005 -open the hood and unscrew the screws that secure the radiator grill and the front panel.

All the same-as-original bumpers from Replace are a perfect option to go if you want to restore and maintain the original look of your vehicle. Youll also need to pull the back side of the 7 pin trailer connector which was a pain. Its not impossible just a pain.

The 2UZ-FE engine can pull around 7200 lbs but the hitch and bumper can only do the 5000 lbs unless you get a Class 4 hitch. It should be a 10mm. Remove the rear bumper.

Inside your trunk remove small back clips in trim panel. Can someone please help me out I thought I saw it on this forum or maybe it was on another forum. I have used the search feature and I still cant find it.

You might have to move the 14 liner over a bit to fond them. Remove the license plate bulb covers. Remove two screws 25 and separate two license plate lights 26 from the rear bumper 27.