2000 Toyota Tundra Remove Driver Side Door Panel Inside

Push in the clips at the back of the door panel.

2000 toyota tundra remove driver side door panel inside. You will note that the bent portion points toward the flat tab. Pull the switch base out window up first remove a couple screws handle and armrest pull the trim panel loose and remove the handle from the panel leaving the cables attached. You may need to hold the latch open in order to access the fastening screw.

1 1 product ratings - 00-06 Toyota Tundra Passenger Side Door Latch Power Lock Act. Toyota Tundra OEM Front Left Door Lock Actuator 2007-2019 Lifetime Warranty Fits. Replacing driver side power window.

00-06 Toyota Tundra Passenger Side Door Latch Power Lock Act. Pry off the door handle bezel with a flat blade screwdriver. Place linkage rod in position on latch handle.

Lift the door up to get the lip off the top edge of the door. Remove the felt in the door handle. Take a screwdriver and remove the screw.

After its loose disconnect the light wires at the bottom and pull the whole panel upwards to remove. Remove the screw and pry the trim to take it out. Engage clip to hold linkage rod to inside latch release handle.

When the panel is put back on you need to loosely place it into position. Make sure you are holding the window glass or. Pull the clips out of the back door panel.