2001 Toyota Tundra Ignition Switch Removal

Insert ignition key and turn to the accessory position.

2001 toyota tundra ignition switch removal. ---- Automotive Locksmith Services in Atlanta GA Metro Area. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. Get a pair of pliers or a small crescent wrench and while trying to turn the key use the wrench to turn the little rod sticking out of the back of the module.

To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. Get a phillips head screwdriver and remove the 2 screws holding the little off-white connector at the rear of the moduleit has the wires to the ignition running to it. Customer was having trouble with the key not working in Ignition lock on a 2001 Toyota Tundra.

The two primary components in a Toyota trucks ignition system are the actual ignition switch and the lock cylinder which work with the ignition key. Tacomas 1995-2004 started by genonetaco. Turn the lock cylinder into the Accessory position with the key and insert a small screwdriver into the hole at the bottom of the ignition switch casting.

Ignition problems with a 2000 Tundra. Put a piece of tape over it as a silencer that way you dont accidentally cut the wrong wire or disable a key function. 2001 Ignition switch assembly.

To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. T he ignition on my 2002 Toyota Tacoma 4x4 TRD locked up after I parked with the left front wheel pushed against a curb vehicle at 40 degree angle to the curb. This is the 4th time in the last 2 weeks this has occured so where do I.

The Tundras ignition lock cylinder itself can go bad over time. Genuine Unistrut P2750-EG 4 Wheel Light Duty Trolley Assembly for use with P1000 P1001 P5000 P5001 P5500 P5501 and All 1-58 or Taller Strut Channel. When I got ready to leave the Fed Ex place I had parked at the key would not turn in the ignition.