2005 Toyota Tundra No Communication With Scanner

I have a 2005 Toyota Tundra.

2005 toyota tundra no communication with scanner. If you run across a 2008 Toyota Tundra 3UR-FE and have a no start no ECM communication condition and there is no Check Engine Light bulb illuminated during the function check disconnect the secondary air valvesThese have a tendency to short the 5 volt reference line and stop all ECM communication. To solve your problem go to the actron website and order the upgrade kit. I tried checking for codes with my bluetooth code scanner but had a hell of a time getting it to talk to the car.

It showed no errors and that everything was fine. THEY COULDNT GET THE OBDII TO COMMUNICATE SO THEY WOULDNT PASS THE VEHICLE BECAUSE THEY COULDNT DO THE EMISSIONS TEST. Carhartt Set Covers Request for your wisdom.

Photos of where to find connector in car. These are the connections that power the ODB2 scannerreader that you connect. Diagnostic Link Connector No.

Look for signs for corrosion or damage. It will take several minutes for the ECU to receive the. I checked the 75amp fuse under the dash and it was good.

Auterra scan tools support all 1996 and newer vehicles. Same day as general mechanic Auto Electrician with shop WAS able to get his scanner to communicate with my trucks computer. 2003 Toyota Tundra Cant Scan Computer Hello There I Gota 2003 Toyota Tundra 4 Door Crew Cab And The Check Engine Light Its On I Try To Scan With 3 Diferent Obdii Scanner And.

Since you have a 2001 Tundra the communication protocol is ISO-9141 which uses just pin 7 K line for bidirectional communication with pin 5 as the signal GND pin 15 the L line is not used or required and there is no copper connection present. Today I had a 2018 Toyota Tundra 57 pick up truck towed into my shop. THERE ARE NO CHECK ENGINE OR OTHER LIGHTS ON AND THE VEHICLE DRIVES.