2007 Toyota Tundra 5.7 Starter Removal

Changed the starter on my 2008 Toyota Tundra 57 LTR 2wd without taking it apart.

2007 toyota tundra 5.7 starter removal. 1 disconnect battery 2 remove any wires connected to the starter 3 remove mounting bolts 4 catch the starter and manouver it through your suspincion 5 you may need to reverse 2 and 3 depending on how hard the wires are to get to 6 now revers these steps with new starter. These are long and only need to be turned a couple of turns to loosen and you can get them the rest of the way out by hand if your hands are small enough and use a long wedge bar over the frame and under the starter to relieve the tension on the starter as it loosens. Remove the solenoid connection.

The easy way to replace the starter without removing any exhaust components or touching it. Only had to remove the rear heat shield and push the main heat shield up an. Pull the plastic hinged plate from the wiring connection and remove the 12mm bolt 9.

I got in to start it and just heard a the starter screaming with no bendix engage. 759 to 1099 Customized for your location Estimate includes. ColorConnex Coupler Plug Kit 3 Piece Automotive Type C 14 in.

I assume the shaft fatigued and failed right at the gear. With 14 mm wrench remove the top and bottom starter mounting bolts. 15 hours to remove and 45 minutes to replace.

Transmission Drain Plug Gasket Engine Oil Crush Washer Seal Rings Replacement for 4Runner Sequoia Tacoma Tundra Lexus GS450H IS F IS250350 LS430 LS460 Replaces 35178-30010 M12 Pack of 10pcs. The stater on my 2007 tundra 57 will spin but not engage replaced starter and the issues starts as soon as you connect the battery what could cause this problem. I have a 2007 toyota tundra 57.

Pull the wires away removing them from a metal clip on the frame. Slide the starter back and rotate the solenoid toward you. I wasnt upset I feel like 10 years and 200k miles was a.